VSCOM NetUSB-400i Manuel d'utilisateur télécharger pdf (Page 16)

4 Windows Utility

After Selecting IP Conﬁguration as Static key-in the desired IP Address of the NetUSB-400i in the

IP Address ﬁeld followed by proper Subnet Mask and Gate Way (ﬁgure 19) values. In DHCP mode

these parameters are given by the DHCP server, so this mode disables the three IP parameter

boxes.

Figure 19: USBIP IP Settings Static

Note: Every board in the network is identiﬁed by its IP address. The USBIP Admin Utility treats

each IP address as a unique device. Even if only the IP Address of the NetUSB-400i is modiﬁed it

treats the same NetUSB-400i as a diﬀerent device.

Password: The Password page allows you to Enable / Disable or change a password on the NetUSB-400i

USB Server. The Password page is shown as ﬁgure 20.

Figure 20: USBIP Conﬁgure Password

Check or uncheck the upper Modify box to Enable or Disable the password option NetUSB-400i

USB Server. Check the lower box to enter a New Password. To protect against typing errors the

password must be given twice.

Note: The only way to clear a wrong or forgotten password is the Default button (section 6.2).

4.1.2 Upgrade Firmware

The NetUSB-400i USB Server Firmware can be upgraded remotely using the Firmware upgrade

option. Select the server in the Server Manager window, and click the Upgrade Firmware button.

October 2009 NetUSB-400i User Manual 16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Pas de commentaire

VSCOM NetUSB-400i Manuel d'utilisateur Page 16